MacDon HC10 for D-Series - Manual (Page 54)

UNLOADING AND ASSEMBLY
4. Remove the knife drive coupler (A), draper drive
coupler (B), the case drain coupler (C) and its
extension tube (D).
Figure 3.40
5. Retrieve coupler bracket (A) from bundle and position
the coupler bracket (A) onto housing.
6. Reinstall the draper drive coupler (B) in original location
and install the knife drive coupler (C) onto the end of
the new bracket (A).
Figure 3.41
7. Install the tee-fitting (A) and union (B) onto motor
case drain.
8. Reinstall the case drain coupler (C).
9. Route the conditioner case drain hose (D) (45°
bent tube) behind the motor and connect to the tee
fitting (A).
Figure 3.42
169254
46
Rev. D