Metal Sales Soffit Panel - Manual (Page 44)

© Metal Sales Manufacturing Corporation / Subject to change without notice, effective 02/09.
43
ARCHITECTURAL
INSTALLATION NOTES
Z-Closure
Double Bead Tape Sealant
Fastener (by others)
Roof Panel
Moisture Barrier (by others)
Rakewall
Reglet Flashing
Pop-Rivet (1'-0" o.c.)
Tube Sealant
Pancake Head Woodscrew (1'-0" o.c.)
1. If panel ends off module bend flat part of the panel up a minimum of 1", otherwise skip to the next note.
2. Apply a row of Double Bead Tape Sealant to the flat part of the panel next to the panel rib or vertical field bent leg.
3. Position Z-Closure over tape sealant and fasten to wood substrate with #10-12 x 1" Pancake Head Woodscrew, 12" o.c.
Fastener must penetrate through the Z-Closure, Tape Sealant, and panel.
4. Install Rakewall to the Z-Closure with
1 /
8
" x 3 /
16
" Pop Rivets at 12" o.c.
5. Install Reglet in field cut groove in the parapet wall. Seal Reglet to parapet wall with Tube Sealant.
6. If two or more flashings are required, lap the flashing over the previously installed flashing by a minimum of 2" placing a
bead of Tube Sealant between the flashings and securing with pop rivets 2.5" o.c.
RAKEWALL WITH REGLET DETAIL
3:12 Slope
Minimum