Metal Sales Soffit Panel - Manual (Page 20)

© Metal Sales Manufacturing Corporation / Subject to change without notice, effective 02/09.
19
ARCHITECTURAL
7LQ VQLSV RU D QLEEOHU W\SH HOHFWULF WRRO DUH UHFRPPHQGHG IRU ¿HOG FXWWLQJ $UFKLWHFWXUDO SDQHOV &XWWLQJ WKH VWHHO JHQHUDWHV
slivers or metal chips. These slivers and metal chips must be immediately removed from the Architectural panels because
WKH\ ZLOO GDPDJH WKH ¿QLVK DQG VKRUWHQ WKH OLIH RI WKH SURGXFW
2QH PHWKRG RI SUHYHQWLQJ WKLV SUREOHP LV WR ÀLS WKH SDQHOV RYHU ZKHQ FXWWLQJ 7KLV DOORZV WKH VOLYHUV DQG PHWDO FKLSV WR EH
brushed from the back side and avoids damaging the paint on the top side of the panels.
:KHQ FXWWLQJ PHWDO SDQHOV JRJJOHV PXVW EH ZRUQ IRU H\H SURWHFWLRQ
CAUTION
All product surfaces should be free of debris at all times. Installed surfaces should be
wiped clean at the end of each work period. Never cut panels over metal surfaces.
Metal shavings will rust on the surface, voiding the warranty.
$OO SDLQWHG SDQHOV DQG ÀDVKLQJV KDYH D IDFWRU\ DSSOLHG EDNHG RQ ¿QLVK +DQGOLQJ DQG LQVWDOOLQJ SDQHOV PD\ UHVXOW LQ VRPH
VPDOO VFUDWFKHV RU QLFNV WR WKH SDLQW ¿QLVK 7RXFKXS SDLQW LV DYDLODEOH LQ PDWFKLQJ FRORUV IURP 0HWDO 6DOHV ,W LV UHFRP-
mended that a small brush be used to apply touch-up paint to those areas that are in need of repair. Touch-up paint does not
KDYH WKH VXSHULRU FKDON DQG IDGH UHVLVWDQFH RI WKH IDFWRU\ DSSOLHG SDLQW ¿QLVK DQG ZLOO QRUPDOO\ GLVFRORU DW DQ DFFHOHUDWHG
rate. Aerosol paint should not be used because of the overspray that may occur.
FIELD CUTTING AND TOUCH-UP
TOUCH-UP PAINT
FIELD CUTTING
TOUCH-UP PAINT
SPRAY PAINT