Metal Sales Soffit Panel - Manual (Page 28)

© Metal Sales Manufacturing Corporation / Subject to change without notice, effective 02/09.
27
ARCHITECTURAL PRO-LOC (CDF) INSTALLATION ( CONT
.)
STEP
3
INSTALLING SECOND PANEL
1. Field notch second panel rib for Starter installation.
2. Apply a continuous bead of tube sealant inside panel rib and insert Inside Closure at base of panel.
3. Rotate second panel in place (positions 1, 2, and 3 see below), and slide pan into Starter. Make sure
panel ends are aligned.
4. Attach panel to substrate with proper fastener and proper spacing as required by local building codes.
5. Repeat Steps 1, 2, and 3 for remaining panels.
Position 1
Insert anchor leg
into formed receiving
groove of previously
fastened panel.
Position 2
Rotate panel over
fasteners of previous
panel.
Position 3
Inspect rib to insure
entire anchor leg
is firmly seated in
receiving groove and
fasten firmly to roofing
structure.
Properly position panel
keeping ends flush
Square panel to wall end
Double Bead Tape Sealant
Starter Flashing
Base Flashing Insert Inside
Closure before
installing second
panel