Lenze ApplicationTemplate PackML (PLC Designer R3-x) - Manual (Page 5)

Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014
5
About this documentation
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
Further technical documentation on Lenze products
Further information on Lenze products which can be used in connection with Controller-based
Automation can be found in the following documentation:
Target group
This documentation addresses to all persons who plan, commission, and program a Lenze
automation system on the basis of the Lenze "ApplicationTemplate PackML" as part of the
"Controller-based Automation".
Screenshots/application examples
All screenshots in this documentation are application examples. Depending on the firmware
version of the Lenze devices and the software version of the engineering tools installed (»PLC
Designer«), the screenshots in this documentation may deviate from the screen representation.
Mounting & wiring Icons
 Mounting instructions
• Controller
• Communication cards (MC-xxx)
• I/O system 1000 (EPM-Sxxx)
• Inverter
• Communication modules


Printed documentation
Online help in the Lenze Engineering
tool/
software manuals and communication
manuals are provided as PDF files on
the Internet.
Using sample applications/an application template

Online help/software manuals
• i700 Application Sample
• Application Samples
• ApplicationTemplate
• ApplicationTemplate PackML
Parameterisation, configuration, commissioning

Online help/software manuals
• Controller
• i700 servo inverter
• Servo Drive 9400 HighLine/PLC/
regenerative power supply module
• Inverter Drive 8400 StateLine/HighLine/TopLine
• 1000 I/O system (EPM-Sxxx)
 Online help/communication manuals
• Bus systems
• Communication modules