Lenze ApplicationTemplate PackML (PLC Designer R3-x) - Manual (Page 32)

Opening the ApplicationTemplate PackML
32
Lenze · ApplicationTemplate PackML · 1.0 EN - 05/2014
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
7 Opening the ApplicationTemplate PackML
General procedure
The main steps are summarised in the following table:
The commissioning steps in detail
The following section provides a detailed description of every commissioning step.
Please follow the instructions below carefully to commission your automation system.
Step Activity
1st  Create a new project - open the ApplicationTemplate PackML ( 33)
2nd  Updating the controller in the project (optional) ( 34)
3rd  Going online ( 34)
• Compiling the project data ( 34)
• Transferring the project to the control - "Log in" ( 34)
4th  Downloading and starting the PLC program ( 34)
5th  Getting started - operating the ApplicationTemplate PackML ( 35)

Further information on the parameter setting and configuration of the respective bus
system can be found in the communication manuals for the corresponding bus system: