12 parameter reference, C01501 | resp. to communication error with mci, C01503 | mci timeout – Lenze E84DGFCC User Manual
Page 75: Parameter reference, Communication manual 8400 motec canopen
EDS84DMOTCAN EN 3.0 - 11/2011
L
75
Communication manual 8400 motec CANopen
Parameter reference
Communication-relevant parameters of the operating system
12
Parameter reference
This chapter complements the parameter list and table of attributes in the software
manual and the »Engineer« online help for the Inverter Drive 8400 motec by the
parameters for CANopen communication.
12.1
Communication-relevant parameters of the operating system
This chapter lists communication-relevant parameters of the 8400 motec operating
system in numerically ascending order.
C01501
C01503
Software manual/»Engineer« online help "Inverter Drives 8400 motec"
Here you can find general information on parameters.
Parameter | Name:
C01501 | Resp. to communication error with MCI
Data type: UNSIGNED_8
Index: 23074
d
= 5A22
h
Configuration of monitoring modes for the communication unit
Selection list
0 No Reaction
1 Fault
4 WarningLocked
Subcodes
Lenze setting
Info
C01501/1
1: Fault
Resp. to MCI error 1
• Response to a communication error.
C01501/2
1: Fault
Resp. to MCI error 2
• Response to an incompatible communication unit.
;
Read access ; Write access CINH PLC STOP No transfer COM MOT
Scaling factor: 1
Parameter | Name:
C01503 | MCI timeout
Data type: UNSIGNED_16
Index: 23072
d
= 5A20
h
Setting range
(min. value | unit | max. value)
0
ms
1000
Subcodes
Lenze setting
Info
C01503/1
200 ms
MCI timeout
;
Read access ; Write access CINH PLC STOP No transfer COM MOT
Scaling factor: 1