Lenze E84DGFCC - Manual (Page 10)

Communication manual 8400 motec CANopen
About this documentation
Terminology used
10
L
EDS84DMOTCAN EN 3.0 - 11/2011
1.3 Terminology used
Term Meaning
Controller Lenze frequency inverter of the "Inverter Drives 8400 motec" product series
Standard device
Drive unit
Communication unit
Wiring unit
The 8400 motec controller consists of the following modules: "drive unit",
"communication unit", and "wiring unit".
• The drive unit is available in various power classes.
• The communication unit is available in the following versions:
–No fieldbus
–AS-i option
–CANopen option
–PROFIBUS option
–PROFINET option
–EtherCAT option
• The wiring unit provides flexible connection options for an easy integration
into the power supply of the machine.
»Engineer« PC software from Lenze which supports you in "engineering" (parameter setting,
diagnosing, and configuring) during the entire life cycle, i.e. from planning to
maintenance of the commissioned machine.
Code Parameter which serves to parameterise and monitor the controller. In normal
usage, the term is usually referred to as "Index".
Subcode If a code contains more than one parameter, these parameters are stored in
"subcodes".
In this documentation a slash "/" is used as a separator between the code and
subcode (e.g. "C00118/3").
In normal usage, the term is also referred to as "Subindex".
Lenze setting These are settings with which the device is preconfigured ex works.
Basic setting
HW
Hardware
SW Software

Note!
Some of the terms used originate from the CANopen protocol.