Lenze Controller-based Automation - Manual (Page 45)

Lenze · Controller-based Automation · System Manual · DMS 1.4 EN · 04/2014 · TD17
45
4 System components
4.5 Bus systems
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.5.4 EtherCAT combined with PROFINET (Lenze Controller as slave)
The "Controller-based Automation" system supports further bus systems in the optional mixed
operation in order to make it possible to integrate further field devices.
The EtherCAT bus system can be used in combination with PROFINET.
This is reasonable if ...
• not all field devices used are available for the same bus system, or
• a motion bus (EtherCAT) is required in parallel to the PROFIBUS.
EtherCAT (as motion bus) and PROFINET (as logic bus)
[4-7] Sample configuration (EtherCAT/PROFINET bus system): Controller 3221 C on a Siemens control

Note!
In the Lenze automation system, no PROFINET master functionality is supported. In a
PROFINET network, a Lenze Controller can only be driven as I/O device (slave), e.g. by a
Siemens SIMATIC S7 PLC. For this purpose, the optional MC-PND communication card
has to be installed in the Controller.
Controller c300/p300 do not support any PROFINET communication.