Lenze Controller-based Automation - Manual (Page 15)

Lenze · Controller-based Automation · System Manual · DMS 1.4 EN · 04/2014 · TD17
15
4 System components
4.1 Engineering tools
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4 System components
This chapter describes the single components of the Lenze Controller-based Automation" system.
The system consists of an Engineering PC, a Controller and devices which communicate with the
Controller via the fieldbus.
4.1 Engineering tools
The Engineering PC is a PC/laptop with a Windows operating system and a network connection. Use
the Engineering PC to do the following with the "Controller-based Automation" system...
• Parameterising/ configuring;
• programming
• diagnosing.
The Lenze Engineering tools by means of which you establish and operate the desired automation
solution in the Engineering phases supported by Lenze are installed on the Engineering PC.