JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 90)

6 Configuration
90
6.11.1 General
Setup dialog
Parameters
NOTE!
In the setup program, the NV connecting list is in the configuration level of the relevant input/
output module (here: multichannel controller module). In the multifunction panel, there is a
central NV connecting list in the configuration menu of the central processing unit.
NOTE!
If the configuration of a program generator is changed, all program generators that are run-
ning stop and are set to basic status to prevent potential malfunctions.
Parameter Selection/settings Description
Function Without function Program generator is switched off.
Program generator Program generator is controlled by a
program.
Fixed-setpoint generator The program generator operates as a
fixed-setpoint generator. In this case,
the setpoint values for the basic status
or manual mode are used.