JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 44)

5 Operation
44
5.5.1 Program generator
Program generator operation (option) covers the following settings and functions:
•
Selecting a program
• Specifying the program section and delay time for program start
• Starting and stopping the program
• Changing the program temporarily
• Changing to manual mode and setting the setpoint values and operating contacts
• Displaying setpoint values, operating contacts, program names and sections, tolerance
band signal, and running times
Generator screen – overview of the nine program generators
This overview shows the following information for all activated program generators:
•
Function: program generator (or current program) or fixed-setpoint generator
• Current program section of first program channel
• Remaining running time of program
To select a program generator, touch the relevant box. Program generators shown on a gray
background are switched off and cannot be selected. The colors of the background and fore-
ground – except for gray – can be configured for each program generator (central processing
unit).
The "Start/Stop" and "Info" tabs always relate to the selected program generator.
If only one program generator is switched on, the Start/Stop screen of the relevant program
generator is displayed in place of the overview.
NOTE!
The channel and setpoint value of the program generator must be assigned to the input sig-
nal (setpoint value) of the relevant controller channel in the controller module NV connecting
list.