JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 139)

139
10 Online parameters
10.5 Date and time
This dialog window is used to set the date and time of the system. These can be entered di-
rectly or can be synchronized with the PC on which the setup program is running.
By contrast, the settings for the time zone and daylight saving time are set in the general set-
tings for the project (project configuration).
 Operating manual B 705000.6 (setup program)
Setup dialog
Parameters
NOTE!
If the project includes a multifunction panel, the date and time must be set on the multifunc-
tion panel. They are transferred when the system state is "Stop" or when the system is
switched on from the central processing unit.
Parameter Selection/settings Description
Date / time in the
device Select "Read out permanently" button The current date and time are read out
from the system in cycles.
To set the date and time, the cyclical
read-out must first be cancelled ("Stop"
button).
New setting Use date/time from PC The PC's date and time settings are
used for setting in the system.
Enter date / time The entered date and time are used for
setting in the system.
Set Select the "Set" button The date and time are set according to
the selection in the "New setting" pane.
Synchronize Select the "Synchronize" button The time is synchronized according to
the selection in the "New setting" pane.
If the difference between the current
time in the system and the new time is
greater than 30 seconds, the function is
not executed.