JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 130)

9 Program editor
130
9.4 Process steps (as of version 02)
In the program generator with process steps (extra code 228 required) a certain process step
is assigned to each program section. All process steps which have been assigned to the con-
cerning program generator are available for this purpose. As a result, the requirements defined
in the process step apply to the concerning program section. This means that only the admis-
sible setpoint values and operating contacts are used and that the section time lies within the
predefined limits.
The PLC programmer can identify the assigned process step by means of setpoint value 12:
The integer value represents the process step number.
Setup dialog
Parameter
Parameter Selection/settings Description
Cut Select the button Use this button to cut lines (process
steps) that have been marked.
Copy Select the button Use this button to copy lines (process
steps) that have been marked.
Insert Select the button Use this button to insert lines (process
steps) that have been cut or copied
above a selected line.
Add empty line Select the button Use this button to insert an empty line
above a marked line (process step).
Delete Select the button Use this button to delete lines (process
steps) that have been marked.
No.
Number
Select process step from 1 to 100 to be
programmed (starting with process step
1) Number of the process step