JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 49)

49
5 Operation
Generator screen – program channel selection in manual mode
This screen appears when the button (3) for changing the setpoint values and operating con-
tacts is pushed.
Generator screen – setting the setpoint values and operating contacts in manual mode
(1)
(2)
(3)
(4)
(1) Setpoint value 1 to 4 in selected program
channel 1
(2) Upper limit of the tolerance band (for set-
point value 1)
(3) 16 operating contacts in the selected pro-
gram channel 1 (contact 1 = right)
(4) Lower limit of the tolerance band (for set-
point value 1)