JUMO 705001 mTRON T - Central Processing Unit Operating Manual - Manual (Page 50)

5 Operation
50
Generator screen – information about the selected program generator
16 operating contacts can be defined in each of the three program channels (maximum three
program channels). These are linked with OR, so that 16 operating contacts are available for
each program generator.
Operating with barcode scanner
Operating the program generator is also possible by reading barcodes; the following functions
are supported:
•
Program selection (program number 1 to 99)
• Program start
• Program stop
The corresponding barcodes can be found in the operating manual of multifunction panel 840
(B 705060.0).
(1)
(2)
(3)
(4)
(5)
(6)
(1) Setpoint values (2) Operating contacts
(3) Tolerance band signal of setpoint value 1 (4) Runtimes
(5) Switch to next program channel (if avail-
able)
(6) Current program section