HYDAC HMG 3000 - Manual (Page 68)

HMG 3000 Page 68
Edition 11/2007 - V02 R01-S02 Stock no.: 669712
Transfer configuration to sensor
This menu enables you to transfer existing
SMART sensor configurations to the
SMART sensor. This is particularly useful
when you want to put new SMART
sensors into operation and want to reuse
settings previously entered for other
SMART sensors.
Display stored sensor configuration
This enables you to have a configuration
displayed which is stored in the
HMG 3000.
You are then shown detailed information
on the sensor configuration selected by
you.
Delete stored sensor configuration
This menu enables you to delete a sensor
configuration. Selected the configuration
and select Delete on the function bar.
6.4.2.6 Set sensor bus address
This menu enables you to assign a bus
address to a sensor. To do this, select a
value from the list and click on Apply on
the function bar.
Bus addresses have to be specified when
the SMART sensor is operated in a bus
system.
(This function is not described further
here).