HYDAC HMG 3000 - Manual (Page 31)

HMG 3000 Page 31
Edition 11/2007 - V02 R01-S02 Stock no.: 669712
6.1.4 Changing the Initial Setup
The Change initial setup item is a submenu
of the Settings menu.
To make changes to the initial setup, press
OK
. You can now change the following
items:
Language
You can choose between German, English
and French. Select your language using the
arrow keys, followed by OK.
Setting/Correcting the Date and Time
Various format options are offered
depending on the language selected by you
and the associated regional formatting
applicable to the date and time. Make your
selection, followed by pressing OK. Then
enter the current date and time via the
numerical keypad
and save your entries via
OK
.
Automatic Measurement Units
This subitem refers only to HSI sensors with
automatic sensor detection. When the
sensors are connected, the unit of
measurement of the sensor is read out and
automatically taken over.
If, for example, you want all pressure
transmitters featuring automatic sensor
detection to show psi readings, you can
make this setting here.
For a connected 0 – 100 bar pressure
transmitter, the HMG then shows the
measured values in a measurement range of
0 – 1450 psi, i.e. the measurement range
and the unit of measurement are
automatically converted.