EZWatch Pro 3.1 - Manual (Page 87)

87
Set up storage device: This button is to
enable the system configured video
storage. To enable the configured device,
sim ply check the device and click the “O K ”
button to complete. Selects your video
storage location (C:\, D:\, etc). Since C:\
usually stores O.S., it is best to store the video files on an alternative hard drive
if one is available.
Add/remove storage device: This function is to detect the new storage device,
but the DVR system need to be restart. This button must be clicked after a HDD
drive is removed or added to your system. Otherwise, the program may not find
playback video files. Clicking this will close your application, please remember to
restart it.
Please perform this function if you find that the playback function is working
abnormally. Running this function could repair video clip and rebuild the
Database of video clips and reindex the database.
Setup Video Compression: This
section provides you with the ability to
control video recording compression and
quality. You can control the video
quality with the compression control
slider. Move the slider to the right for a
crisper picture or move the slider to left
for smoother video playback. Note:
The CPU will use more power when the
slider is set higher. The data rate slider bar controls the amount of data that is