EZWatch Pro 3.1 - Manual (Page 146)

146
1. Strip away all of the cable and shielding so you
have ½ ” of the center conductor is exposed as
shown.
2. Then strip away the black covering so you have
¼ ” of the Shielding exposed. Do not allow any of
the copper shielding to touch the center
conductor.
3. Insert the cable into the fitting and gently find the
hole for the center conductor before you press
the fitting on the wire. Now just twist the fitting
on the wire while firmly pressing down until
the fitting is firmly on the cable.
7-5. How to wire a Multi-camera Power Supply
#1. At the camera location, take the power cable and
strip away the outer sheathing to expose the inner
tw o w ires (black & red). Then strip aw ay about ¼ ” of
the wires jacket to expose the copper wire. Do the
same to the power wire pig tail which connects to the
camera power connection as shown. Note: Do not
strip or cut the power lead coming directly from the
cam era. You should strip the “pig tail” pow er cable
w hich cam e w ith your kit. You should have one “pig
tail” for each cam era
.
#2. Now take the red power cable lead and twist it
together with the black & whites lead from the power
wire pig tail. Now take the black lead from the power
cable and twist it together with the all black lead from
the power wire pig tail. Use the gray wire nuts
provided with your system and twist them onto the