EZWatch Pro 3.1 - Manual (Page 77)

77
Com Port You m ust select “Auto” from the draw m enu of ―C om P ort ―icon
when you want to enable the function of Netcom module.
Baud rate You need to select a correct Baud rate if you want to control the
Speed dome camera or P/T/Z camera from Witness DVR board (Default setting
is 9600 bps).
Dip switch of NC-3213USB Control Board:
The dip switch for the bound rate setting, please refer to the table as below:
1.) You must select 9600 baud rate, enable Checksum icon and select
“ Pelco P “ or “ FastC am III “ or “ S D C I-220 “, w hen you use I-V iew ’s
FastCam Speed dome camera series.
2.) The ID 0 of Pelco “ P “ is sam e as C am era 1 of D V R , ID 1 same as
camera 2.
Select Modem For EZModem user or using Phone/Pager notify function should
select which modem will be used and enable “M onitor‖ below to communicate
with DVR. If user’s m odem and fax share one telephone line, user m ust
disable ”m onitor‖ when no more connection required otherwise modem will
occupy phone line always.
1.) You can select “N one” to leave m odem open for other com m unication
software or voice calls.
2.) You m ust select w hich m odem w ill be used and enable “M onitor” for
Baud
rate
Switch
240
0
480
0
960
0
192
00
S1 ↓ ↑ ↑ ↓
S2 ↑ ↓ ↑ ↓