Wireless hf power, Wireless config selection, Automatic – ETC Unison Paradigm Handheld Touchscreen and Wireless Accessories User Manual
Page 29: Manual, Wireless config, Settin

Handheld Touchscreen and Wireless Accessories User Manual
25
Wireless HF Power
Wireless HF Power is the power that the Handheld Touchscreen antenna is currently using.
By default, this is set to 10 dBm. Selection is available up to 18 dBm. The higher the power,
the stronger the wireless signal range will be for the Handheld Touchscreen.
When increasing Handheld power, also increase the Wireless Access Station and/or
Docking Station power using LightDesigner. The values should match the Handheld so
bidirectional communication will always be possible.
Wireless Config Selection
Configure the Handheld Touchscreen to wait for a manual configuration selection when a
wireless signal is connected or automatically select the configuration for loading. By default,
the Handheld is set to Automatic configuration selection.
The Handheld Touchscreen by default automatically selects the assigned configuration
based on the wireless device it receives the strongest signal from.
Automatic
Selecting Automatic allows the Handheld Touchscreen to select a configuration
automatically based on signal strength.
Manual
Selecting Manual allows the user complete control over when to switch configurations.