Dakota Ultrasonics DFX-8 plus MANUAL1 - Manual (Page 116)

Dakota Ultrasonics
112
Note: The screenshots above show where all the possible locations for polarity
selection are found in the DFX-8. For more information on the above, refer to
the sections on VIEW, DAC, GT1, & GT2.
1) Press the MENU key once to activate the menu items tab. Press the MENU
key multiple times to tab right, and the ESC key multiple times to tab left,
until the DISP, DAC, GT1, or GT2 menu is highlighted and displaying the
submenu items. Alternatively, press the LEFT and RIGHT arrow keys
multiple times using the left button wheel.
2) Use the UP and DOWN arrow keys multiple times on the left button
wheel to scroll through the sub menu items until VIEW, DPOLARITY,
POLARITY1, or POLARITY2 is highlighted.
3) Use the LEFT and RIGHT arrow keys on the right button wheel to
toggle the VIEW, DPOLARITY, POLARITY1, or POLARITY2 negative or
positive.
4) Press the MEAS key to return to the measurement screen and begin taking
readings.
11.19 Auto Find
The DFX-8 is equipped with a very handy feature for locating the detection point of a
return echo that is not currently in the viewable region of the display. The AUTO
FIND feature is a convenient way to automatically bring the detected echo into view
on the display. Once the echo is in the viewable area, the user can then make small
adjustments to the delay and range accordingly. The procedure to use the AUTO
FIND feature is outlined below:
Using Auto Find