Carbolite ABA 7/35B User Manual
Page 60
60
MF60
– 1.04
21.12 Catch Tray Straightening
The stresses caused by repeated heating and cooling can cause the catch tray (Fig: 2.2.2) to
distort, allowing the catch tray to rock in use, giving an unstable balance reading. The distortion
takes the form of two opposite corners bending up and the other two opposite corners bending
down.
Straighten the tray by resting the two lower corners on supports, and pressing down on the
higher corners. Repeat this operation until the tray is flat.
21.13 Consumables
Printer Paper: standard till roll paper 2¼
’ (57mm) wide Carbolite part number 22-222-356-0010.
Printer Ribbon: Epson ERC-09.
See also other documents in the category Carbolite Kiln:
- Peak Series (16 pages)
- AX30 (12 pages)
- GP Series (16 pages)
- GPC Series (16 pages)
- LHT Series (16 pages)
- HRF (MF05) (16 pages)
- HRF 7/45 (12 pages)
- TLD Series (12 pages)
- CR Series (16 pages)
- MTT 12/38/850 (16 pages)
- CF 15 - CF 60 (20 pages)
- PTC 12/20/150 (16 pages)
- CFM Series (16 pages)
- AAF Series (16 pages)
- SNF Series (12 pages)
- HZS Series (16 pages)
- Work Tube End Seals (12 pages)
- MTF Series (16 pages)
- TZF Series (16 pages)
- GHA Series (24 pages)
- TZF Series (16 pages)
- STF Series (20 pages)
- EHA Series (28 pages)
- CWF Series (16 pages)
- ABF 8/28 (16 pages)
- VCF Series (16 pages)
- ELF Series (16 pages)
- HTR 11/75 (16 pages)
- HST Series (16 pages)
- STF Series (20 pages)
- VST 17/-- (16 pages)
- BLF 17/3 (16 pages)
- RHF Series (17 pages)
- HTF 17 (20 pages)
- RHF Series 3 litre - 35 litre (16 pages)
- CDF 15/1b (16 pages)
- CAF 16/38 (16 pages)
- CAF DIGITAL IMAGING (52 pages)