4 filter setting – Carbolite ABA 7/35B User Manual
Page 51
51
MF60
– 1.04
17.3.1 Screen-view Balance Control Screen - Calibration
17.4 Filter Setting
The white number box, next to Filter Setting screen label, can be touched to change the
balance filter setting. The controller will display the number pad and a value from 1 to 3 can be
entered. The effect of the filter numbers are explained below:
1 = minimal filter
– fastest response (default setting after power up)
2 = medium filter
3 = maximum filter
– slowest response
When a filter setting is changed the status will read ‘Setting filter x’ then ‘Filter x set’, followed by
‘Ready’, where x is the filter number being set.
See also other documents in the category Carbolite Kiln:
- Peak Series (16 pages)
- AX30 (12 pages)
- GP Series (16 pages)
- GPC Series (16 pages)
- LHT Series (16 pages)
- HRF (MF05) (16 pages)
- HRF 7/45 (12 pages)
- TLD Series (12 pages)
- CR Series (16 pages)
- MTT 12/38/850 (16 pages)
- CF 15 - CF 60 (20 pages)
- PTC 12/20/150 (16 pages)
- CFM Series (16 pages)
- AAF Series (16 pages)
- SNF Series (12 pages)
- HZS Series (16 pages)
- Work Tube End Seals (12 pages)
- MTF Series (16 pages)
- TZF Series (16 pages)
- GHA Series (24 pages)
- TZF Series (16 pages)
- STF Series (20 pages)
- EHA Series (28 pages)
- CWF Series (16 pages)
- ABF 8/28 (16 pages)
- VCF Series (16 pages)
- ELF Series (16 pages)
- HTR 11/75 (16 pages)
- HST Series (16 pages)
- STF Series (20 pages)
- VST 17/-- (16 pages)
- BLF 17/3 (16 pages)
- RHF Series (17 pages)
- HTF 17 (20 pages)
- RHF Series 3 litre - 35 litre (16 pages)
- CDF 15/1b (16 pages)
- CAF 16/38 (16 pages)
- CAF DIGITAL IMAGING (52 pages)