Software setup, Default settings, Efault – Atop Technology SE8502-M12 User Manual User Manual
Page 9: Ettings
User manual Version 1.1
SE8502-M12 IP68 Serial Server
Copyright © 2010 Atop Technologies, Inc.
All rights reserved
5
RJ-45
Pin 1 2 3 4 5 6 7 8
Signal
Rx+
Rx-
Tx+
Tx-
2.
Software Setup
Now the SE8502-M12 hardware is installed and power is on, network IP configuration will be set in this
section.
2.1. Default
Settings
The SE8502-M12 has an IP addresses one for Ethernet interface. These default settings are shown from under
information
Default IP addresses
Interface
Device IP
Subnet mask
Gateway IP
LAN port
10.0.0.50.100
255.255.0.0
10.0.0.254
The other default settings of SE8502-M12 are shown in the following table
Property
Default Value
Ethernet Port
IP Address
10.0.50.100
Gateway
10.0.0.254
Subnet Mask
255.255.0.0
Security
User Name
Admin
Password
Null (Leave it blank)
Serial
COM
9600/None/ 8/1,No flow control, packet delimiter disabled
Link Mode
TCP Server, Listen port 4660/4661,No Filter, Virtual COM disabled
SNMP
SysName of SNMP
Name (System Name)
SysLocation of SNMP
Location (System Location)
SysContact of SNMP
Contact (System Contact)
Table 1.
Default settings of the SE8502-M12 device