Atop Technology SE5416A Quick Start - Manual

Atop Technologies Inc.
Industrial Serial Device Server
SE5408A / SE5416A Series
Hardware Installation Guide
Version 1.0
Updated on April 2013
Tel: 886-3-5508137
Fax: 886-3-5508131
www.atop.com.tw
PN: 89900422G
Package Check List
Check whether your package contains following items:
 SE5408A / SE5416A Industrial Serial Device Server
 Hardware Installation Guide with Warranty Card
 Product CD
 3-pin Terminal Block (DC models only)
 RJ-45 to Male DB9 cable
 AC Power Cord (EU / US models only)
 Foot Rubbers
 Rack Mount Kit
Panel Layout
*SE5408A has its serial ports 9-16 covered up compared to SE5416A
LCM Display
Buttons Function
Open Main Menu or go back one level higher
Scroll up
Scroll down
Confirm the selection. When working with IP
addresses, pressing means moving to the
next digit
Installation Overview
1. Ground the device properly. If you are using the AC model,
you can use the grounding screw next to the AC inlet. Else,
if you are using the DC model, you can use the FG pin in
the terminal block. It is required to connect to the grounds at
all times to ensure overall maximum performance.
2. If you opt to place the device on a rack, your will need to
secure the rack mounts kit on to the device before placing it
on the rack. If you opt to place the device on a surface, you
can put on the foot rubbers to prevent the device from
sliding.
3. You can then choose whether to plug in the I/O ports at this
point or do it later. Next you can then proceed to connect
the device to the LAN (switch or PC), take care on using the
RJ-45 connector; after this we can then proceed to the
device’s settings.

The openings to the sides are for the devices heat
dissipation. Please never obstruct or cover them with any
objects.

SE5416A ’s factory IP by default is 10.0.50.100. You can
access the device by its WebUI once it is connected to a
physical network or use Serial Manager, for more
information on Serial Manger, please refer to its manual.
Please be aware that the PC needed for this procedure
needs to be in the same subnet, or you may refer yourself
to the device’s manual on Web UI configuration.
Pin Assignments
Serial and RJ-45 Connectors
Ethernet RS-232 RS-422 RS-485
Pin 1 Tx+ RTS - -
Pin 2 Tx- DTR TX- -
Pin 3 Rx+ TXD TX+ -
Pin 4 SG SG SG
Pin 5 SG SG SG
Pin 6 Rx- RXD RX+ Data+
Pin 7 DSR RX- Data-
Pin 8 CTS - -