Udp mode, Serial settings – Atop Technology SE8502-M12 User Manual User Manual

Page 22

User manual Version 1.1
SE8502-M12 IP68 Serial Server

Fig 23. TCP Client in Link mode

3.4.4.

UDP Mode

SE8502-M12 can be configured in a UDP mode to establish connection using Unicast or Multicast data from the
serial device to one or multiple host computers. Vice versa is also true. For example, the original RS-422/ RS485 bus
can be transferred and extended connected distance by SE8502-M12s.

The destination IP is assigned by single IP or group IPs, The configuration is limited by the Local Listening Port. For
example, on SE8502-M12 listening port is 4660 which receive data sending from the host computers. SE8502-M12
can support up to 8-group IPs for UDP connection, if users needed.

Fig 24. UDP protocol in Link mode

Note: In this phase, UDP mode does not support Virtual COM mode.

3.4.5.

Serial Settings

This filed can be configured with serial parameters for SE8502-M12. Here User can configure Serial parameters,
include UART Mode, baud rate, parity, data bit and type of flow control.