Brother MFC 9200C - Manual (Page 65)

S E T U P S E N D 6 - 5
Dual Access (Not Available for Color Fax)
You can place an original in the ADF and set temporary settings, dial a number,
and begin scanning the fax into memory—even when the MFC is receiving a
fax, sending a fax, or printing a fax from memory. The LCD shows the new job
number and available memory.
1
Place the original face up in the ADF.
2
Enter the fax number.
3
Press Start . The MFC starts scanning the original and the LCD shows the job
number (#XX) of the fax and how much memory is available. Then the machine
starts dialing. For the next fax, you can repeat steps 1 through 4 immediately.
Note
If you get a MEMORY FULL message while scanning the first page of a fax,
press
Stop to cancel scanning. If you get a MEMORY FULL message while
scanning in a subsequent page, you’ll have the option to press Start to transmit
the pages scanned so far, or to press Stop to cancel the operation.
Note
Your MFC normally operates in Dual Access mode. However, to send a color
fax, you must override Dual Access and use Real Time Transmission.
The number of pages you can scan into memory varies with the data they
contain.