Amp mate-n-lok, Din connectors, Exclusions – JLG 460SJ ANSI Service Manual User Manual
Page 410: Amp mate-n-lok -6 din connectors -6 exclusions -6, Use of seal plugs -6
SECTION 7 - BASIC ELECTRICAL INFORMATION & SCHEMATICS
7-6
– JLG Lift –
3120788
AMP Mate-N-Lok
Follow the installation instructions.
DIN Connectors
This connector is typically used on hydraulic valves. Fol-
low the installation instructions.
Exclusions
A limited number of connectors do not benefit from dielec-
tric grease, or may be permanently damaged by applica-
tion. Dielectric grease may not be required in properly
sealed enclosures.
BRAD HARRISON / PHOENIX CONTACT M12
The connector uses gold contact material to resist corro-
sion and an o-ring seal for moisture integrity. If dielectric
grease is mistakenly applied to this connector system, the
low-force contacts cannot displace the grease to achieve
electrical contact. Once contaminated, there is no practi-
cal way to remove the dielectric grease (replacement of
female contacts required). The JLG Load Sensing System
and 1250AJP Rotary Angle Sensors are examples of com-
ponents with the M12 connector system.
Figure 7-6. Use of Seal Plugs