JLG 460SJ ANSI Service Manual - Manual (Page 27)

SECTION 1 - SPECIFICATIONS
3120788 – JLG Lift – 1-7
1.14 OPERATOR MAINTENANCE AND
LUBRICATION
LUBRICATION INTERVALS ARE BASED ON MACHINE OPERA-
TION UNDER NORMAL CONDITIONS. FOR MACHINES USED IN
MULTI-SHIFT OPERATIONS AND/OR EXPOSED TO HOSTILE
ENVIRONMENTS OR CONDITIONS, LUBRICATION FREQUEN-
CIES MUST BE INCREASED ACCORDINGLY.
NOTE: The following numbers correspond to those in Figure
1-2., Operator Maintenance and Lubrication Dia-
gram.
NOTE: It is recommended as a good practice to replace all
filters at the same time.
1. Swing Bearing - Internal Ball Bearing
Lube Point(s) - 2 Grease Fittings
Capacity - A/R
Lube - MPG
Interval - Every 3 months or 150 hrs of operation
Comments - Fittings in center of bearing: Remote
Access is optional
1 7 6 4
8
3 9 20
21, 22
14,15,16,17,18,19
8,9,10,11,12,13
5
Figure 1-2. Operator Maintenance and Lubrication Diagram
Table 1-22. Lubrication Specifications
KEY SPECIFICATIONS
MPG Multipurpose Grease having a minimum dripping point of 350°
F (177° C). Excellent water resistance and adhesive qualities,
and being of extreme pressure type.
(Timken OK 40 pounds minimum.)
EPGL Extreme Pressure Gear Lube (oil) meeting API service classifi-
cation GL-5 or MIL-Spec MIL-L-2105
HO Hydraulic Oil. API service classification GL-3, e.g. Mobilfluid
424.
EO Engine (crankcase) Oil. Gas - API SF, SH, SG class, MIL-L-
2104. Diesel - API CC/CD class, MIL-L-2104B/MIL-L-2104C.
OGL Open Gear Lubricant - Mobiltac 375 or equivalent.