Apple IIe Card - Manual (Page 37)

2. Connect the device’s cable connector to the smaller of the two
connectors on the Y-shaped cable, as shown in the figure.
Again, be sure the connectors line up correctly, and tighten the
connector screws to ensure a proper fit.
You can connect only one Apple IIe device at a time to the smaller
connector on the Y-shaped cable. If you want to use more than one
device, you’ll need to swap the devices.
▲
Warning: If you want to swap drives or devices connected to the
Y-shaped cable, be sure to turn off the computer first. If you change
devices while the computer is on, you may damage the device or
the computer, or both.
▲
Chapter 1: Preparing the Equipment 21