Apple IIe Card - Manual (Page 153)

My Apple IIe program won’t start up from the built-in
3.5-inch disk drive
■
Make sure you’ve designated the built-in drive as the startup drive.
Use the SmartPort panel and the “Changing the SmartPort Settings”
section in Chapter 5 to confirm or change 3.5-inch drive
configurations.
■
Make sure you’ve set the SmartPort panel correctly so that the drive
you’ve chosen as your startup drive is slot 5 drive 1.
■
Make sure the Startup option in the Slot Configuration panel is set
to Scan or to slot 5.
■
Make sure the disk is not copy-protected. Some copy-protected
program disks won’t work in a built-in drive. If the disk is copy-
protected, try using it in an external UniDisk 3.5 Drive.
My Apple IIe program won’t start up from a UniDisk 3.5 Drive
■
Make sure the disk drive is connected correctly to the Macintosh LC.
(See Chapter 1 for instructions.)
■
If you are using a UniDisk 3.5 Drive and an Apple 5.25 Drive, make
sure the disk drives are correctly daisy-chained together, with the
UniDisk 3.5 Drive first in the chain. (See Chapter 1 for instructions.)
■
Make sure you’ve designated the UniDisk 3.5 Drive as the startup
drive. Use the SmartPort panel and the “Changing the SmartPort
Settings” section in Chapter 5 to confirm or change 3.5-inch drive
configurations.
■
Make sure you’ve set the SmartPort panel correctly so that the drive
you’ve chosen as your startup drive is slot 5 drive 1.
■
Make sure the Startup option in the Slot Configuration panel is set
to Scan or to slot 5.
Appendix A: Troubleshooting 137