Apple IIe Card - Manual (Page 35)

■
If you have a UniDisk 3.5 Drive and two Apple 5.25 Drives, first connect
the UniDisk 3.5 Drive to the Y-shaped cable. Then connect the first Apple
5.25 Drive to the UniDisk 3.5 Drive by plugging the connector from
the 5.25 Drive into the port on the back of the UniDisk 3.5 Drive. Then
connect the second 5.25 Drive to the first 5.25 Drive by plugging the
connector from the second 5.25 Drive into the port on the back of the
first 5.25 Drive.
▲ s ▲ s
Important: If you plan to use both a UniDisk 3.5 Drive and one or more
Apple 5.25 Drives with the Macintosh LC, you must position the UniDisk
drive first in the daisy chain. The disk drives will not work correctly if a
5.25 Drive is positioned first in the chain.
▲ s ▲ s
▲
Warning: If you want to swap drives or devices connected to the Y-shaped
cable, be sure to turn off the computer first. If you change devices while the
computer is on, you may damage the device or the computer, or both.
▲
UniDisk
3.5 Drive Apple
5.25 Drive Apple
5.25 Drive
Chapter 1: Preparing the Equipment 19