Xerox WorkCentre M165-M175-3093 - Manual (Page 52)

Page 4-4 Quick Reference Guide
Output
Output is used to select the finishing requirements for the job. The options will
depend on the finishing output device installed.
Options:
Collated Select Collated for output stacked in sets to match the sequence of the originals.
Uncollated Select Uncollated for output sorted into stacks of individual pages.
Hole Punched This option is available if your machine is equipped with a finisher and a 2 Hole or
3 Hole Punch. Each sheet is punched individually, so there is no limit to the number
of sheets in the set. Additional Hole Punch kits can be purchased as an option.
L Hole punching can only be selected for 8.5 x 11" long edge feed, and 11 x 17"
paper.
NOTE: Some stapling options can be used in conjunction with the Hole Punch.