Konica Minolta bizhub 4750 User Manual
Page 59
1.5
Available operations in Administrator mode
1
[Applied Functions]
1-53
[Read Community
Name]
Enter a read-only community name (using ASCII characters of up to 15 bytes,
excluding spaces, \, ,' ,", and #).
[public] is specified by default.
[Write]
Select whether or not to enable the read and write functions.
[Enable] is specified by default.
[Write Community
Name]
If [Write] is set to [Enable], enter the community name in the read-write enable
state (using ASCII characters of up to 15 bytes, excluding spaces, \, ,' ,", and
#).
[private] is specified by default.
[SNMP v3 Settings]
Configure the SNMP v3 settings.
[Context Name]
Enter a context name (using ASCII characters of up to 63 bytes, excluding
spaces, \, ,' ,", and #).
[Discovery]
Select whether or not to allow a user for detection.
[Enable] is specified by default.
[Discovery User
Name]
If [Discovery] is set to [Enable], enter a user name for detection (using ASCII
characters of up to 32 bytes, excluding spaces, \, ,' ,", and #).
[public] is specified by default.
[Read User Name]
Enter a read-only user name (ASCII characters of up to 32 bytes, excluding
spaces, \, ,' ,", and #).
[initial] is specified by default.
[Security Level]
Select a security level for the read-only user.
[Auth-password/Priv-password] is specified by default.
[auth-password]
Enter an authentication password for the read-only user (using ASCII charac-
ters between 8 and 32 bytes, excluding spaces, \, ,' ,", and #).
To enter (change) the password, select the [Change Password] check box,
then enter a new password.
[priv-password]
Enter a privacy password for the read-only user (using ASCII characters be-
tween 8 and 32 bytes, excluding spaces, \, ,' ,", and #).
To enter (change) the password, select the [Change Password] check box,
then enter a new password.
[Write User Name]
Enter a user name used by the read and write user (using ASCII characters of
up to 32 bytes, excluding spaces, \, ', ", and #).
[restrict] is specified by default.
[Security Level]
Select a security level of the read and write user.
[Auth-password/Priv-password] is specified by default.
[auth-password]
Enter an authentication password for the read and write user (using ASCII
characters between 8 and 32 bytes, excluding spaces, \, ,' ,", and #).
To enter (change) the password, select the [Change Password] check box,
then enter a new password.
[priv-password]
Enter a privacy password for the read and write user (using ASCII characters
between 8 and 32 bytes, excluding spaces, \, ,' ,", and #).
To enter (change) the password, select the [Change Password] check box,
then enter a new password.
[Encryption Algo-
rithm]
Select an encryption algorithm.
[DES] is specified by default.
[Authentication
Method]
Select an authentication algorithm.
[MD5] is specified by default.
[Trap Settings]
Configure the settings on the SNMP TRAP function.
[Allow Setting]
Select whether or not to allow a notification of the status of this machine using
the SNMP TRAP function.
[Enable] is specified by default.
[Trap Setting when
Authentication
Fails]
Select whether or not to send TRAP when authentication fails.
[Disable] is specified by default.
Item
Description