Konica Minolta bizhub 4750 User Manual
Page 39
1.5
Available operations in Administrator mode
1
[Applied Functions]
1-33
8
From [IPsec Policy] on [IPsec] screen, click [Edit], then configure the following settings.
9
In the administrator mode, select [Security] - [IPsec] - [Communication Check], then check that a con-
nection with a peer can be established normally by the specified setting.
% Enter the peer's IP address into [IP Address], then click [Check Connection].
[Cookies]
Select whether or not to enable the defense using Cookies against denial-of-
service attacks.
[Disable] is specified by default.
[ICMP Pass]
Select whether or not to apply IPsec to the Internet Control Message Protocol
(ICMP).
Select [Enable] to allow the ICMP packets to pass without applying IPsec to
the ICMP.
[Enable] is specified by default.
[ICMPv6 Pass]
Select whether or not to apply IPsec to the Internet Control Message Protocol
for IPv6 (ICMPv6).
Select [Enable] to allow the ICMPv6 packets to pass without applying IPsec to
the ICMPv6.
[Enable] is specified by default.
[Default Action]
Select an action to be taken if no settings meet the [IPsec Policy] while IPsec
communication is enabled.
Select [Deny] to discard IP packets that do not meet the [IPsec Policy] settings.
[Allow] is specified by default.
Item
Description
[Name]
Enter a name for the IPsec policy (using up to 10 characters).
[Peer]
Select a peer setting.
Select the setting from those registered in [Peer] on the [IPsec Settings]
screen.
[Protocol Setting]
Select an appropriate protocol.
Select the setting from those registered in [Protocol Setting] on the [IPsec Set-
tings] screen.
[SA]
Select a peer setting.
Select the setting from those registered in [SA] on the [IPsec Settings] screen.
[Communication Type]
Select a direction of IPsec communication.
[Action]
Select an action to be taken for the IP packets that met [Peer], [Protocol Set-
ting], and [Communication Type].
•
[Protected]: Protect the IP packets that met the conditions.
•
[Allow]: Do not protect the IP packets that met the conditions.
•
[Deny]: Discard the IP packets that met the conditions.
•
[Refuse]: Refuse the IP packets that met the conditions.
Item
Description