Konica Minolta bizhub 4750 - Manual (Page 45)

1.5 Available operations in Administrator mode 1
[Applied Functions] 1-39
[Default Settings] - [Tray Mapping Settings]
To display: Administrator mode - [Print] - [Default Settings] - [Tray Mapping Settings]
Specify the paper tray to be used for printing when a print job is received by the printer driver of other com-
panies.
[Default Settings] - [PCL Settings]
To display: Administrator mode - [Print] - [Default Settings] - [PCL Settings]
Configure the PCL settings.
[Default Settings] - [PostScript Settings]
To display: Administrator mode - [Print] - [Default Settings] - [PostScript Settings]
Configure the PostScript print settings.
Item Description
[Tray Mapping Mode] Select whether or not to enable the tray mapping.
[Off] is specified by default.
[Logical Tray 0] to [Log-
ical Tray 9] Assigns logical trays 0 to 9 to physical trays.
Item Description
[PCL Settings] Specify the default values for PCL printing.
[Font Number] Specify the default font. The displayed font number corresponds to the PCL
font list.
[0] is specified by default.
[Symbol Set] Select the font symbol set to be used.
[PC-8] is specified by default.
[Lines Per page] Enter the number of lines of text data to be printed on one page.
The default value depends on the region the machine is used in.
[Font Point Size] Enter the font size (in points) for proportional fonts (with different widths for
each character).
[12.00] is specified by default.
[Font Pitch Size] Enter the font width (in pitches) for typewriter fonts (with the same width for
each character).
[10.00] is specified by default.
[CR/LF Mapping] Select whether or not to replace the line feed codes when printing text data.
When you want to replace the line feed codes, select the replacement method.
[CR=CR LF=LF] is selected by default.
Item Description
[PostScript Settings] Specify the default values for PostScript print settings.
[Wait Timeout] Specify the time-out period after it is judged as PS error.
If you select [0], time-out will not work.
[0] sec. is specified by default.
[PS Protocol] Select the protocol that is used for PS data communication.
If you select [Auto], an appropriate protocol is automatically determined from
the PS print jobs.
[Auto] is specified by default.
[Print to PS Error] Select whether or not to print error information when an error occurs during PS
rasterization.
[Off] is specified by default.