ADTRAN TSU 600 - Manual (Page 80)

Chapter 3. Operation
68 TSU 600 User Manual 61200.076L2-1
APPLY TEMP > A
Writes the TEMP map into Map A. Apply is usually
the last step in updating a map and is accessed auto-
matically at the end of editing or creating a temporary
map. It can be bypassed at this time by selecting
another menu choice.
Selecting Apply does not disrupt normal data flow while
the current map is overwritten with the new map. This will
not cause a switch of the executing map; i.e., if Map A were
modified while Map B was executing, selecting Apply will
rewrite Map A but will not switch execution from Map B to
Map A.
Access 6)APPLY TEMP > A by following standard
operating procedures or by completing a scratch map.
Press Enter or number 6. The unit displays DISRUPT
DATA: YES or NO.
Scroll to select Yes or No.
Yes The display shows MAP APPLIED.
No The system returns to menu item
6)APPLY.
When the desired selection is displayed, press Enter to
activate the selection, followed by Cancel to return to
menu operation.