Lenovo ThinkVantage ImageUltra Builder Version 5.0 - Manual (Page 55)

Recovery version 1 or 2 program will be installed in a virtual partition and
several additional Rescue and Recovery tools will be installed on the C partition
and added to the Windows Start menu.
v Scenario 3: Installing a Smart Image on a target computer that has a service
partition containing the Rescue and Recovery version 1 or 2 program. In this
scenario, only the maps and modules in the service partition get replaced. No
other modifications are made to the service partition contents.
v Scenario 4: Installing Rescue and Recovery version 4 on a computer that has a
Smart Image installed. The service partition is at the back of the hard disk drive
(SERVICEV001). The name of the ThinkVantage ImageUltra Builder workspace
will change to the Rescue and Recovery workspace and the list of menu items
might be extended to provide more recovery options.
v Scenario 5: Installing Rescue and Recovery version 4 on a Windows XP
computer that has a Smart Image installed. The service partition is at the front of
the hard disk drive (SERVICEV002). Rescue and Recovery will install in a virtual
partition and the user will not be able to access the service partition again. This
scenario is not recommended.
v Scenario 6: Installing Rescue and Recovery version 4 on a Windows Vista or
Windows 7 computer that has a Smart Image installed. The service partition is at
the back of the hard disk drive (SERVICEV001). Rescue and Recovery will install
in a virtual partition. Once the user boots to the virtual partition, you might
need to select Restore to factory contents in order to boot to the service
partition.
v Scenario 7: Installing Rescue and Recovery version 4 on a Windows Vista
computer that has a Smart Image installed. The service partition is at the front of
the hard disk drive (SERVICEV002). The name of the ThinkVantage ImageUltra
Builder workspace will change to the Rescue and Recovery workspace and the
list of menu items might be extended to provide more recovery options.
v Scenario 8: Installing Rescue and Recovery version 4 on a Windows 7 computer
that has a Smart Image installed. The service partition is at the front of the hard
disk drive (SERVICEV003). The name of the ThinkVantage ImageUltra Builder
workspace will change to the Rescue and Recovery workspace and the list of
menu items might be extended to provide more recovery options.
Security dependencies
The ImageUltra Builder program is able to use the device-driver modules from the
HPA during deployment if a driver map is not used. However, in order to do so,
the HPA security settings in the target computer BIOS settings must be set to either
High security
or Medium security. If the security setting is set to Security
disabled , the ImageUltra Builder program does not attempt to use the
device-driver modules from the HPA; instead, it will check to see if a service
partition exists and attempt to use the device-driver modules from the service
partition.
On computers that are not HPA-enabled, there are no corresponding BIOS security
settings. If a Smart Image is deployed without a driver map, the ImageUltra
Builder program always attempts to use the device drivers from the service
partition.
Chapter 3. Staging-area behavior and logic 41