Lenovo ThinkVantage ImageUltra Builder Version 5.0 - Manual (Page 137)

d. If you want to prompt the person performing the installation for a value
for this setting, click the Display the following prompt check box, so a
check mark is visible; then, in the space provided, type the prompt you
want displayed.
e. Click OK.
f. Repeat these steps for each type of setting.
v To automatically run one or more utilities before the menu system is
displayed at the target computer or after the final selection is made from the
final menu, do the following in the Before/After Menu Options tab:
a.
Click either the Before user menus or After user menus radio button,
depending on when you want the utilities to run.
b. Click the Insert Utility icon in the Before/After Menu Options tab. The
Add Utility window opens.
c. In the Add Utility window, navigate to the utility you want to use, click
the utility, and then click OK. The Add Utility window closes and the
utility is added to the Before/After Menu Options tab.
d. Double-click the utility you just added. The Edit Parameters window
opens.
e. In the Parameters field, type any parameters required by the utility.
f. Click OK.
g. Repeat these steps for each utility you want to add.
v To control the order in which either customer-first-boot modules or base
operating-system modules are installed, do the following in the Install
Sequence tab:
a.
Use the drop-down menu to select the type of modules you want to
sequence.
Note: Customer-first-boot modules and Base operating-system modules
are the only modules for which you can set the sequence at a map
level. Customer-first-boot modules appear as selections only if the
install hook attribute of the module was defined as Install during
customer first boot
in the Options tab module window.
b. Highlight the module you want to move.
c. Use the Move Item Up or Move Item Down icon to move the module up
or down in the sequence.
Note: Move modules that need to be installed first into the First box,
then set the sequence within the First box. Move modules that
need to be installed last in the Last box, then set the sequence
within the Last box. In most cases, partitioning modules need to be
installed before other operating-system modules. For base maps,
check the Insert Driver Map modules after this module check box
to determine the install sequence of when the driver map modules
will be installed.
d. When you are finished setting the sequence, click OK.
v To define which files get stored in the service partition of the target
computer after the image is installed, select one of the following from the
Image Cleanup tab.
– If after installation you want the service partition of the target computer
to contain the complete Smart Image, click the Delete none radio button.
Chapter 7. Creating maps 123