WIKA CPC3000 - Manual (Page 6)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 6
11498171.01 08/2009 GB
1.1 FCC Radio frequency emission notice
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interfer-
ence to radio communications. Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be required to correct the interference
at his or her own expense.
Use shielded cables to connect external devices to this instrument to minimize
rf radiation.
1.2 Software license agreement
This product contains intellectual property, i.e., software programs, that are licensed for use
by the end user/customer (hereinafter “end user”).
This is not a sale of such intellectual property.
The end user shall not copy, disassemble or reverse compile the software program.
The software programs are provided to the end user “as is” without warranty of
any kind, either express or implied, including, but not limited to, warranties of
merchantability and fitness for a particular purpose. The entire risk of the quality
and performance of the software program is with the end user.
WIKA, Mensor and its suppliers shall not be held to any liability for any damages
suffered or incurred by the end user (including, but not limited to, general,
special, consequential or incidental damages including damages for loss of
business profits, business interruption, loss of business information and the
like), arising from or in connection with the delivery, use or performance of the
software program.
1.3 Accreditations
WIKA is registered to ISO 9001:2000. The calibration program at WIKA is accredited by DKD,
as complying with both the ISO/IEC 17025:2005 standards. All Mensor primary standards are
traceable to PTB.
Notice
Notice