WIKA CPC3000 - Manual (Page 18)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 18
11498171.01 08/2009 GB
5. Installation
5.1 Introduction
The initial installation of the CPC3000 includes the following steps: Unpack the system, place
it in a suitable workspace, connect it, switch it on and configure.
5.2 Unpacking the system
Unpack all components of the CPC3000 carefully and check the parts for damage. Report
any damage immediately to the forwarding agent.
Apart from any additional components ordered, a shipment consists of:
CPC3000 controller
¼" and 6 mm tube fitting adapters
Main cable
Manual with calibration certificates in the enclosure
Optional: recommend Interface cable or any other accessories ordered
5.3 Dimensions of the available version in mm





The instrument can be set up on a table top or it can be rack-mounted. Rack mount adapters
are optional on the CPC3000 and require an adapter panel.
Rear view
Front view Side view
310
148
191
228
259