WIKA CPC3000 - Manual (Page 31)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 31
11498171.01 08/2009 GB
A gray background on a [PRESSURE UNITS] key indicates that it is the current selection.
Touch any other [PRESSURE UNITS] key, and press [BACK] key to enable change and
return to previous operation screen. All of the displayed pressure values will have changed to
correspond to the newly selected units.
7.7 Bar Chart
The Bar chart shows the relative indica-
tion of the current pressure value with
respect to the full scale value of the
internal sensor and the user defined
minimum and maximum limits (see
chapter "7.8.7 for SETUP of user
defined limits"). The full height of the
bar graph is proportional to the internal
sensor range. The green line indicates
the magnitude of the setpoint. The blue
column indicates the magnitude of the
current pressure. The cross hatched
section indicates the portion of the
internal sensor above or below the user
defined limits that is not being used.
7.8 SETUP Menus
The SETUP menus are opened by pressing the [SETUP] key. This opens the menu
shown in "Figure - SETUP". The SETUP menu has five tabs: [DISPLAY], [CONTROL],
[REMOTE], [INFO] and [SERVICE]. Each tab is described in detail in the following chapters.
The screen below has the
[DISPLAY] tab active.
inter
nal sensor range
User defined limits
Curr
ent pr
essur
e
Setpoint (green line)
portion of the internal sensor range
outside of the user defined limits
Figure - SETUP