WIKA CPC3000 - Manual (Page 20)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 20
11498171.01 08/2009 GB
5.5 Rear panel
Four pneumatic pressure ports are located on the rear panel (see below: "Figure - Rear
panel"). Positioned on the left are the ethernet and RS-232 and GPIB connector, the off/on
switch, the line fuses, and a protective grill covering the ventilating fan.
5.6 Pressure connections
The pressure connections must be installed according to the following
instructions, observing the relevant regulations. The installation should be
performed by persons familiar with, and who can work according to, the
safety regulations for working on pneumatic/hydraulic systems.
When making up a connection to an o-ring adapter port use a back-up wrench
to prevent over-stressing the threads in the manifold block.
All of the pressure ports on the rear are female 7/16 - 20 SAE/MS straight threads per
MS16142 and SAE J514 table 14.
They require a tube fitting boss seal with an o-ring per MS33656.
WIKA provides female 1/4 inch and 6 mm tube fittings with the instrument.
The pressure connections can be made to these adapters with the proper mating hardware.
Do not use sealant on fittings sealed with an o-ring.
Figure - Rear panel
Fan
Mains input socket
Micro fuse
Power supply
Supply Port
Measure/Control Port
Reference Port
Vent
Exhaust/Vacuum Port
IEEE-488.2
Warning
Notice
310
148
191
228
259
Ethernet USB