WIKA CPC3000 - Manual (Page 44)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 44
11498171.01 08/2009 GB
Command Data Response/Function
Decpt? n Returns the number of decimal points
for the active channel. (see Resolution)
Default None Sets the default values.
DHCP Reserved for DHCP SETUP
DHCP? Reserved for DHCP SETUP
DIO Integer 2 turns on digital output, 0 turns it off.
DIO? Bit0 = input, bit1 = output
DOC mm/dd/yyyy Sets the date of cal for the active
sensor and turndown.
DOC? mmddyy Returns the date of cal for the active
sensor and turndown.
DOM? mm/dd/yyyy Returns the date of manufacture.
DUTLABEL Reserved for DUT option
DUTLABEL? Reserved for DUT option
DUTTYPE Reserved for DUT option
DUTTYPE? Reserved for DUT option
DUTAMIN Reserved for DUT option
DUTAMIN? Reserved for DUT option
DUTAMAX Reserved for DUT option
DUTAMAX? Reserved for DUT option
DUTLOOP Reserved for DUT option
Error? text message Returns the next error in the error
queue.
Errorno? Enn-text Returns pcs400 error code and text.
Filter Off, Low, Normal, High Sets the reading filter 0, 80 %, 92 %,
95 %.
Filter? (filter) Returns the reading filter.
Gasdensity Value in lb/cuft Sets the head pressure gas density in
lb/cuft.
Gasdensity? n.nnnnne+nn Returns the head pressure gas density.
Gastemp Value in degrees F Sets the head pressure gas temperature
in degrees F.
Gastemp? n.nnnnne+nn Returns the head pressure gas temper-
ature.
Gateway nnn.nnn.nnn.nnn Sets the Ethernet gateway address.
Gateway? nnn.nnn.nnn.nnn Returns the Ethernet gateway address.
Height Value in inches Sets the head pressure height in
inches.
Height? n.nnnnne+nn Returns the head pressure height.
Id? MENSOR, CPC3000,
ssssss,v.v.vv Ssssss is the serial number, v.vv is the
CPC3000 software version.
Install Start software installer.
IP nnn.nnn.nnn.nnn Sets the IP address of the instrument.