WIKA CPC3000 - Manual (Page 50)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 50
11498171.01 08/2009 GB
Command Data Response/Function
_pcs4 stabledelay? Returns the number of readings
that must be within the stable
window before a stable pressure is
indicated.
_pcs4 stablewindow Sets the pressure window that is
used to indicate pressure is stable.
_pcs4 stablewindow? Returns the pressure tolerance
allowed for a stable pressure
indication as a % of span of the
active transducer.
_pcs4 stat? Returns Mode and stable flag
status “mode, stable CR LF”.
_pcs4 unit Sets the instrument to specified
engineering units.
_pcs4 unit? Returns the current engineering
units and the type of transducer (A,
G, D).
_pcs4 xducer? Returns the number of the currently
active transducer.
_pcs4 xducerid?
_pcs4 zero?
Returns the stored zero offset of
the active transducer & turndown in
the current pressure units.
8.5.3 PCS 200 Commands Emulated
Command Data Response/Function
CX Control Pressure at last control point
and units
C$nnnnnnnX Control Pressure at n in units $
C$nnnnnnnsX Control Pressure at n in units $
D#X CAL POINT CONTROL MODE NOT
SUPPORTED
EX Clear Error/Clear Service Request
E?X Return error code and clear error
F$nnnnnnn1X Re-initialize; $, n ignored
F$nnnnnnn2X RETURN CAL DATA NOT SUPPORT-
ED
F$nnnnnnn3X Return Unit ID string; $,n ignored
F$nnnnnnn5X RETURN QPS TEMPERATURE NOT
SUPPORTED
F$nnnnnnn6X RETURN NULL METER READING
NOT SUPPORTED