WIKA CPC3000 - Manual (Page 34)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 34
11498171.01 08/2009 GB
[Preset Points] allows the operator to select the number of points that appear as steps.
For example: in "Figure - preset points" [5] is entered as the preset points value, this
automatically configures 5 points from 0 to 100 % of user defined range. It automatically
calculates the steps that populate the STEP keypad in the main menu. 
7.8.3 SETUP Remote
Configuration of parameters associated with remote communication are set up in the
MAIN -> [SETUP] -> [REMOTE] screen. Detailed information on SETUP of Ethernet USB and
IEEE-488 are given in chapter 8. "Remote Operation".
The ethernet SETUP key opens a dialog box where host name, IP, netmask, gateway,
port, and client IP can be entered. There is also a check box that will activate (checked) or
deactivate (unchecked) Dynamic Host Configuration Protocol (DHCP). DHCP is a protocol
used by networked devices (clients) to obtain the parameters necessary for operation in an
Internet Protocol network. This protocol reduces system administration workload, allowing
devices to be added to the network with little or no manual configuration. 
Figure - SETUP Remote
Figure - Preset Points