WIKA CPC3000 - Manual (Page 53)

Pneumatic High-Speed Pressure Controller CPC3000
WIKA Operating Instruction Pneumatic High-Speed Pressure Controller ∙ Version 1.1 53
11498171.01 08/2009 GB
Command Data Response/Function
*ESE? Returns enable status event value
*ESR Event status register
*ESR? Returns event status register value
*SRE Service request enable
*SRE? Returns service request enable value
*STB? Returns status byte
8.5.6 SCPI Commands
Notes:
1. if Wika option is enabled, SCPI units are BAR, otherwise SCPI units are the currently select-
ed unit.
This numeric suffix always defaults to 1 and is designated by [R] (range)
Command Response/Function
MEASure
[:PRESsure][R]? Returns the pressure from sensor R
:TEMPerature[R]? Returns the temperature from sensor R
:RATE[R]? Returns the rate/sec from sensor R
:BAROmetric? Returns the barometric pressure
CALibration
[:PRESsure][R]
:MODE? Returns 1=calibrated or 0=not calibrated
:DATE? Returns date of cal “DD,MM,YY”
:DATE Sets date of cal YYYY,MM,DD
:ZERO? Returns zero offset
:ZERO Sets the zero offset
:ZERO:RUN Same as CAL:ZERO 0
:ZERO:INITiate? Returns zero status
:ZERO:INITiate No function
SENSe
[:PRESsure][R]
:NAME? Returns sensor name string
:MODE? Returns “ABSOLUTE” or “GAUGE”
:MODE ABS|GAUGE Sets pressure type
:ABS? Returns native sensor type 0=GAUGE
1=ABSOLUTE
:RESolution? Returns resolution (float)
:RANGe
[:UPPer]? Returns maximum range
:LOWer? Returns minimum range