12 power supply installation, 13 upgrading the vs-6464dn firmware, 14 technical specifications – Kramer Electronics VS-6464DN User Manual
Page 41: Power supply installation, Upgrading the vs-6464dn firmware, Technical specifications, N 13

Power Supply Installation
37
37
12 Power Supply Installation
The VS-6464DN is supplied with three redundant power supplies and can
run on a minimum of two power supplies.
To install a second power supply:
1. Remove the new power supply from its shipping carton and anti-static
bag.
2. Power down the chassis.
3. Align the new power supply with the rails on the bottom of the slot.
4. Slide the power supply into the slot until it makes contact with the rear
connector, insuring that it remains straight.
5. Press the power supply firmly until the front panel of the power supply
is flush with the front panel of the VS-6464DN.
6. Tighten the four thumbscrews to secure the power supply in place.
7. Power on the chassis.
13 Upgrading the VS-6464DN Firmware
Upgrading the firmware on the VS-6464DN can be done only by authorized
service personnel.
14 Technical Specifications
lists the technical specifications of the VS-6464DN.
Table 8: Technical Specifications of the 64x64 Digital Matrix Switcher
BANDWIDTH:
Supports up to 3.2Gbps bandwidth per channel (limited by the
card installed)
MAX RESOLUTION:
Up to UXGA; 1080p
CONTROLS:
Front panel buttons, Infrared remote control transmitter, RS-232,
Ethernet
OPERATING
TEMPERATURE:
0° to +55°C (32° to 131°F)
STORAGE TEMPERATURE: -45° to +72°C (-49° to 162°F)
HUMIDITY:
10% to 90%, RHL non-condensing
DIMENSIONS:
19” x 14.2” x 10U (W, D, H) rack-mountable
POWER CONSUMPTION:
100-240V AC, 50/60Hz, 420VA
WEIGHT:
24.0kg (52.9lbs) approx
ACCESSORIES:
Power cord, Infrared remote control transmitter, PS-1DN power
supply
lists the technical specifications of the cards that are compatible
with the VS-6464DN chassis.